Rotational molding machine specially developed for use in laboratories or rotomolding pilot production for quality tests, pigments, and others. The LAB machine works with a central oven, a cooling station and a cart with an “Offset” arm. This equipment has the same functions and characteristics of a large machine, in other words, it allows a real simulation of process and cycle, with the only difference that this machine uses electric heat (does not use gas burner), what makes it very suitable for installation in laboratories and universities.
MACHINE
DIMENSIONS
LAB 0.50
HA
1580 mm
62 in
CA
3000 mm
118 in
PA
1830 mm
72 in
Ø OVEN
660 mm
26 in
* Measurements are approximate and may be adjusted by the manufacturer.
484 mm
19 in
444 mm
17 in
It has only one support base (chassis) for the entire machine (electric panel, cart and oven). The oven has a horizontal cylindrical shape, with a recirculation fan and recirculation duct. The cart has a square arm type "L", (OFFSET), with 02 gearmotors and variable frequency drives, double cooling system, and others.
It is formed by a set of motors, electrical field and general panel used to program the machine parameters. It also has a full electrical design, easy to interpret, allowing quick checks and agility in maintenance.
Formed by a set of sensors / transducers, a Programmable Logic Controller (PLC) that contains the Manager System LAB 2.70 and the actuators. The PLC runs the management software through which you can track the information recorded by sensors installed in various parts of the machine.
See below a small sample of the variety of products that can be manufactured by the rotational molding process.
Reading Time: 12 minutes
Plastic rotational molding is one of the most important techniques for developing products in this material. If you are looking for a practical guide to understand and achieve the best results in plastic rotational molding, you are in the right place.
Reading Time: 4 minutes
See how to choose the right rotational shaping machine for your business and check out the rotational molding machine options that Rotoline has available for you.
Reading Time: 3 minutes
Rotoline is responsible for the manufacturing and technical support of innovative and revolutionary rotational molding machines for the plastics market.
Reading Time: 4 minutes
Some basic care and of fast execution show the extreme importance of control, detection, and troubleshooting in the rotomoulding machines. After all, the cost of scheduled maintenance is exponentially smaller than the cost of unscheduled maintenance.
Rotoline is a global supplier of Rotational Molding Machines with one of the highest quality standards. Currently, it has machines installed on 5 continents.
MACHINES
ROTOLINE BRASIL
ROTOLINE USA
ROTOLINE EUROPE
